1×1 Hex S6060 iUVC™
Key Features and Benefits:
- Reduced engineering and simplified manufacturing without the need to solder wires
- Highest Wall Plug Efficiency (WPE) in the industry (8%), resulting in shortest irradiation times
- Highest optical power per dollar value in the industry, enabling lowest cost of ownership
- Typical 40mW optical power at 100mA from a single chip, 275nm (268nm – 278nm) wavelength, and 6.5V forward voltage
- 5,000-hour L70 lifetime (does this apply to 3535?)
- Strong roadmap for future wavelength, WPE, and lifetime improvements
- Smallest form factors
- Future proof building block
Applications：
- Engineering builds and testing
- Water, air, surface, and industrial disinfection
Previous
Next
Typical Performance at 250mA (25°C ambient, packaged, Solder point temperature <38°C)
| Parameter | Symbol | Unit | Min. | Typ. | Max |
|---|---|---|---|---|---|
|
Peak Wavelength |
λp |
nm |
268 |
275 |
280 |
|
Radiant Flux |
Φе |
mW |
70 |
100 |
130 |
|
Forward Voltage |
VF |
V |
5.8 |
6.5 |
7.5 |
|
Spectrum Half Width |
Δλ |
nm |
|
10 |
|
|
View Angle |
2Ө½ |
° |
|
150 |
|
|
Thermal Resistance |
RJ-b |
℃/W |
|
8 |
|
Maximum Ratings (25°C ambient, packaged device)
| Parameter | Symbol | Limit | Unit |
|---|---|---|---|
|
Maximum DC Drive Current |
IFM |
350 |
mA |
|
Maximum Pulsed Drive Current |
IFMP |
500 |
mA |
|
Maximum Reverse Voltage |
VRM |
-5 |
V |
|
Maximum Junction Temperature |
Tjmax |
75 |
°C |
|
Operating Temperature Limits |
Topr |
-20 ~ 60 |
°C |
|
Storage Temperature |
Tstg |
-30~ 100 (Humidity <40%) |
°C |
Download Full Product Specifications PDF
DownloadHow can we support your disinfection project today?
Warning
UV emitted from this product. Avoid eye and skin exposure to unshielded product.
UVC LEDs emit deep ultraviolet radiation, with extremely high intensity near their surface. This allows rapid disinfection but safety precautions must be observed during assembly,
testing and field use.
By purchasing the UVC chips (bare dice), packaged LEDs or arrays and from BOLB Inc., the customer agrees to indemnify the manufacturer of any bodily harm as a result of failure to follow the common sense precautions, or warnings and guidelines contained within this Specifications.
It is the buyer’s responsibility to properly design products that ensure safety of end users.
All assembly workers, operators and bystanders must wear eye and skin protection when the UVC LEDs are energized. Bare-eye observation (including through microscopes) and bare-hand handling of a UVC LED in operation is PROHIBITED.
UVC light can be easily absorbed, so any oil or other absorbent liquid or solid substance must NOT be allowed to touch the sapphire side of the UVC chip, or the dome lens on a packaged LED.
