S6060 SMD 265 nm
Key Features and Benefits:
- World’s Most Efficient High-Power UVC LED (“Wall Plug” Efficiency of 7%)
- Highest Power Single-Chip UVC LED: 100mW at 250mA, 263-273nm, 140mW @ 350mA
- Highest mW/$ UVC LED
- Measured, Documented and Certified L70 Lifetime of 8,000 hrs. (targeted up to 10,000 hrs., see datasheet)
- Applications: Water Disinfection, Air Disinfection, Horticulture, Food Safety, Surface Disinfection.
- Industry Standard 6x6mm SMD Package
- Zero Ozone, RoHS and Reach compliant, UL tested and certified
Previous
Next
Typical Performance at 250mA (25°C ambient, packaged, Solder point temperature <38°C)
Maximum Ratings (25°C ambient, packaged device)
| Parameter | Symbol | Unit | Min. | Typ. | Max |
|---|---|---|---|---|---|
|
Peak Wavelength |
λp |
nm |
263 |
265 |
268 |
|
Radiant Flux |
Φе |
mW |
90 |
100 |
- |
|
Forward Voltage |
VF |
V |
6.5 |
7.0 |
7.5 |
|
Spectrum Half Width |
Δλ |
nm |
9 |
10 |
11 |
|
View Angle |
2Ө½ |
° |
|
150 |
|
|
Thermal Resistance |
RJ-b |
℃/W |
|
10 |
|
| Parameter | Symbol | Limit | Unit |
|---|---|---|---|
|
Maximum DC Drive Current |
IFM |
350 |
mA |
|
Maximum Pulsed Drive Current |
IFMP |
500 |
mA |
|
Maximum Reverse Voltage |
VRM |
-5 |
V |
|
Maximum Junction Temperature |
Tjmax |
75 |
°C |
|
Operating Temperature Limits |
Topr |
-20 ~ 60 |
°C |
|
Storage Temperature |
Tstg |
-30~ 100 (Humidity <40%) |
°C |
Download Full Product Specifications PDF
DownloadHow can we support your disinfection project today?
Warning
UVC LEDs emit deep ultraviolet radiation with extremely high intensity near their surface. High
irradiance allows rapid disinfection, but users must observe safety precautions during assembly,
testing, and field use.
By purchasing the UVC chips (bare dice), packaged LEDs, or arrays from BOLB Inc., the customer
agrees to indemnify the manufacturer of any bodily harm due to failure to follow the commonsense precautions or warnings and guidelines contained within this Specification.
It is the buyer’s responsibility to design products that ensure the safety of end users.
All assembly workers, operators, and bystanders must wear eye and skin protection when the UVC
LEDs are energized. Therefore, bare-eye observation (including through microscopes) and bare-hand
handling of a UVC LED in operation is PROHIBITED.
Because most materials readily absorb UVC light, any oil or other absorbent liquid or solid substance
must NOT be allowed to touch the sapphire side of the UVC chip or the dome lens on a packaged
LED.
